Last Updated on August 6, 2020 by Forest Master The tension of the belts should be checked before each use. Additionally, when the machine is new or after the belts […]
FAQs
Checklist for your Wood Chipper
Last Updated on August 6, 2020 by Forest Master You should perform regular maintenance checks on your wood chipper. This is the best way to ensure optimal performance and long […]
How to fit replacement pull start for MLR52 2-Stroke Engine
Last Updated on August 5, 2020 by Forest Master The replacement pull starts are slightly larger than the original stock pull starts on the engine and more robust. Therefore, some […]
Black Drain Bolt is too tight to unscrew
Last Updated on August 3, 2020 by Forest Master The black drain 8mm hex is also the dipstick on the other side of the drain bolt, it’s best to try […]
Does the bleed screw need to be tightened after use?
Last Updated on August 3, 2020 by Forest Master Yes, the bleed screw must be tightened after you have finished using it. The air vent allows air into the machine, […]
No Power to Log Splitter – Capacitor Failure
Last Updated on August 3, 2020 by Forest Master The capacitor in the electric motor can fail from misuse over time. When operating the log splitter, we strongly advise that […]
How do I wire up the microswitch below the hinged section of the 6.5 Wood Chipper?
Last Updated on July 22, 2020 by Forest Master There should be two wires from the microswitch/hopper opening switch, a male bullet connector and a “washer connector”. The “washer connector” […]
How to Remove and Replace the Short Motor
Last Updated on July 22, 2020 by Forest Master The splitter should be turned upside down and left for a little while before removing the pump and motor assembly, this […]
